Heating devices

Designed for all Woodcast products

Two different heating devices are available: Woodcast A001 Heating Device and Woodcast Express A002 Heating Device.

Heating Device A001

The extremely easy to use Woodcast A001 is designed for heating all flat Woodcast products. It gets products warm ready for the treatment process. It accommodates up to 80 cm long Woodcast casting sheets.

Once the products are heated up to 65 degrees they are completely pliable and ready to use.

Heating times with Woodcast A001

Woodcast 1 mm Ribbon: 3 – 5 min
Woodcast 2 mm Rigid and 2 mm Soft: 6 – 8 min
Woodcast 4 mm Rigid: 10 – 15 min

Woodcast product moulding and setting times

Woodcast 1 mm Ribbon: 30–60 sec, fully set 3–5 min
Woodcast 2 mm Rigid and 2 mm Soft: 3–5 min, fully set 5–10 min
Woodcast 4 mm Rigid: about 5 min, fully set 10–15 min

Express Heating Device

The Woodcast Express Heating Device speeds up the heating time significantly. In this device you can heat up both Woodcast sheets and preformed orthoses in just a few seconds. This means you can adjust preformed orthoses over and over again.

Heating times with Woodcast Express A002

Woodcast 1 mm Ribbon: short cycle (approx. 40 seconds)
Woodcast 2 mm Rigid and 2 mm Soft: medium cycle (approx. 100 seconds)
Woodcast 4 mm Rigid: long cycle (approx. 3 minutes)

Woodcast product moulding and setting times

Woodcast 1 mm Ribbon: 30–60 sec, fully set 3–5 min
Woodcast 2 mm Rigid and 2 mm Soft: 3–5 min, fully set 5–10 min
Woodcast 4 mm Rigid: about 5 min, fully set 10–15 min

Woodcast material

Heating devices

Accessories

After you have typed in some text, hit ENTER to start searching...